Enterasys Networks VHSIM2-A6DP - Manual (Page 62)

Port Framer Configuration Screen
3-28 Local Management
3.9 PORT FRAMER CONFIGURATION SCREEN
The Port Framer Configuration screen is used to enable or disable ATM statistics and alarms, and
to specify, if applicable, the transmission type that the APIM will use (SONET or SDH). The Port
Framer Configuration screen allows these configurations to be performed on both the primary and
redundant APIMs.
To access the Port Framer Configuration screen, perform the following steps:
1. Use the arrow keys to highlight the PORT FRAMER CONFIGURATION menu item from
the Physical Port Configuration Menu screen.
2. Press ENTER. The Port Framer Configuration screen, Figure 3-11 , displays.
Figure 3-11 Port Framer Configuration Screen
The following list explains each of the Port Framer Configuration screen fields.
Physical Port (Toggle)
This field is used to select which APIM to be configured. This field toggles between 1 (APIM 1)
and 2 (APIM 2).
RETURN EXIT
Physical Port:
ATM Port Type:
Statistics:
Alarms:
Idle Cells:
Cell Payload Scrambling:
Transmission Type:
[1]
ATM IF: 155Mbps, SONET/SDH, OC-3, MMF, SC
[ OFF ]
[ OFF ]
[ UNASSIGNED ]
[ ON ]
[ SONET ]
SAVE
28251_16