Enterasys Networks VHSIM2-A6DP - Manual (Page 58)

ATM Connection Setup By Virtual Interface Screen
3-24 Local Management
3.7 ATM CONNECTION SETUP BY VIRTUAL INTERFACE SCREEN
The ATM Connection Setup by Virtual Interface screen is used to view all current connections for
each LAN Emulation Client (LEC) that has been configured on the VHSIM2-A6DP on a
LEC-by-LEC basis. This screen will also display PVCs that have been set up on the
VHSIM2-A6DP. PVCs will display one at a time in Secure Fast Mode, because they are
considered individual Virtual Interfaces. However, the PVCs will be displayed grouped by
interface number in the 802.1Q mode.
To access the ATM Connection Setup By Virtual Interface screen, perform the following steps:
1. Use the arrow keys to highlight the CONNECTIONS BY VIRTUAL INTERFACE menu
item on the ATM Connections screen.
2. Press ENTER. The ATM Connection Setup By Virtual Interface screen, Figure 3-9 , displays.
Figure 3-9 ATM Connection Setup By Virtual Interface Screen
The following list explains each of the ATM Connection Setup By Virtual Interface screen fields:
Total Bandwidth Allocated (Read-Only)
Shows the resources the current APIM has available for the assignment of PVCs and their
associated traffic descriptors. If there are no PVCs configured, the maximum bandwidth that the
active APIM supports is displayed. For example, an APIM-21 will display 155 Mbps. As PVCs
with traffic descriptors are assigned, their rate is subtracted from the total.
RETURN
Virtual Interface #: [28]
VPI VCI Encapsulation
0 32 VC Mux 802.3 Bdg
0 32 VC Mux 802.3 Bdg
Application Port #: 28
ATM Address (ESI)
2825_14
Total Bandwidth Allocated: 0 Mbps
Type
TRAFFIC
CATERGORY RATE INDEX
UBR 155Mbs 1
UBR 155Mbs 1
EXIT