Enterasys Networks VHSIM2-A6DP - Manual (Page 55)

Add/Delete Entry Screen
Local Management 3-21
3.6 ADD/DELETE ENTRY SCREEN
The Add/Delete Entry screen is used to create, modify, or delete PVCs.
To access the Add/Delete Entry screen from the ATM Connection Setup screen perform the
following steps:
1. Use the arrow keys to highlight the ADD/DELETE command at the bottom of the ATM
Connection Setup screen.
2. Press ENTER, the Add/Delete Entry screen, Figure 3-8 , displays.
Figure 3-8 Add/Delete Entry Screen
The following list explains each Add/Delete Entry screen field:
VPI (Modifiable)
Used to enter the Virtual Path Identifier of the PVC. The available range for this field is 0 or 1,
with a default value of 0.
VCI (Modifiable)
Used to enter the Virtual Channel Identifier of the PVC. The available range for this field is 32
through 1019.
NOTE: The Add/Delete Entry screen will display only if the host device has been set
to operate as a SecureFast switch with the VHSIM2-A6DP installed. Refer to the Local
Management chapter of the host device for instructions on configuring the host device
for this type of operation.
RETURN
VPI VCI AAL Type Encapsulation Type
0 0 [ 5 ] [VC Mux 802.3 Bdg]
EXIT ADD/MODIFY
2825 13