1 changing the lec status of an existing lec, 2 configuring a new lec automatically, Changing the lec status of an existing lec -44 – Enterasys Networks VHSIM2-A6DP User Manual
Page 78: Configuring a new lec automatically -44, Section 3.13.1, Section 3.13.2
LEC Administration Screen
3-44
Local Management
3.13.1 Changing the LEC Status of an Existing LEC
To change the LEC Status, perform the following steps:
1.
Use the arrow keys to highlight the MODIFY MODE command at the bottom of the screen
and press ENTER.
2.
Use the arrow keys to highlight the LEC Index field.
3.
Enter the Index of the LEC to be modified, and press ENTER.
4.
Use the arrow keys to highlight the LEC Status field.
5.
Use the SPACE bar to toggle between the options (Active or Not In Service) until the desired
option displays.
6.
Use the arrow keys to highlight the SAVE command and press ENTER. The new LEC Status
becomes enabled.
3.13.2 Configuring a New LEC Automatically
To configure a new LEC automatically, perform the following steps:
1.
Ensure the LEC Administration screen is in CREATE MODE. If the screen does not display
“CREATE MODE”, perform the following substeps:
a.
Use the arrow keys to highlight the CREATE MODE command at the bottom of the
screen.
b. Press ENTER. The LEC Administration screen, in CREATE MODE, displays.
2.
Use the arrow keys to highlight the LANE Version field.
3.
Press the SPACE bar to toggle between the options (1.0 or 2.0) until the desired LANE version
displays.
4.
Use the arrow keys to highlight the Configure LEC field.
5.
Press the SPACE bar to toggle between the options until Automatic displays.
NOTE: To discover the Index of the LEC that will be modified, refer to
.