Enterasys Networks VHSIM2-A6DP - Manual (Page 67)

ATM Port Redundancy Configuration Screen
Local Management 3-33
TEST PORTS NOW (Command)
Used to instruct the VHSIM2-A6DP to perform an APIM redundancy test immediately. When the
test is completed, the results are displayed in the Port Usability/Status field.
RESET TO FACTORY DEFAULTS (Command)
Used to reset all the fields in the ATM Port Redundancy Configuration screen to their default
settings.
SAVE (Command)
Used to save all changes to memory.
3.10.1 Setting the Redundancy Status
To set the Redundancy Status, perform the following steps:
1. Use the arrow keys to highlight the Redundancy Status field.
2. Press the SPACE bar to toggle between the choices until the appropriate mode displays
(Enabled or Disabled).
3. Use the arrow keys to highlight the SAVE command at the bottom of the screen and press
ENTER. The changes are saved to memory.
3.10.2 Setting the Primary Port
To set the Primary port, perform the following steps:
1. Use the arrow keys to highlight the Primary port field.
2. Enter 1 or 2. Entering 1 signifies APIM 1 of the VHSIM2-A6DP. Entering 2 signifies APIM 2
of the VHSIM2-A6DP.
3. Use the arrow keys to highlight the SAVE command at the bottom of the screen and press
ENTER. The changes are saved to memory.