Edelbrock 2010 - Manual (Page 10)

©2013 Edelbrock LLC
Part #1596, 1597, 1598, 1599 Brochure #63-1598
Rev. 3/25/13 - QT/mc
Edelbrock E-Force Supercharger System for
the 2010-2013 Camaro SS
Installation Instructions
Page 9
• Put the car into Acc mode, but don’t start the vehicle.
• Connect the supplied PCM cable to the OBD-II connector.
• Use directional pad to highlight Program Vehicle option
and press Select button.
• Use directional pad to highlight Return To Stock option
and press Select button.
• Follow the on screen instructions. Turn the car off when
prompted to do so by the handheld programmer.
• Read parting message from programmer then press
Select to continue.
• Unplug the programmer cable from the OBD-II port.
• When you are ready to Install the supercharger, proceed
with Step 1 and you will be prompted to re-flash the ECU
towards the end of the installation procedure.
Supercharger Installation
1. Open trunk and lift trunk liner to access plastic hold down.
Unscrew plastic hold down then remove air compressor and
foam support.
2. Use a 10mm socket to loosen and remove the negative
battery terminal.
3. Lift the protective cover then use a 10mm socket to
loosen and remove the positive battery terminal.
4. Lift and support the front end of the vehicle using a
service lift or jack and appropriately load rated jack stands
then loosen and remove the lug nuts from both front wheels.
Remove the wheels and set them aside.
5. Use a T20 Torx wrench to remove the three bolts on each
side holding the front and the two holding the rear of the
front wheel fender liners. Use a panel puller to remove the
five body pins on each side that retain the inner fender wells
then remove them and set them aside.
6. Reach in through the wheel wells with a 10mm socket to
remove the four bolts at the front of each side of the fascia
then use a 7mm socket to remove the two bolts on each
side of the front fascia.
7. Disconnect the fog lamp electrical connectors and the
fascia wiring harness connector on the passenger side.