Edelbrock 2010 User Manual
Page 26
©2013 Edelbrock LLC
Part #1596, 1597, 1598, 1599
Brochure #63-1598
Rev. 3/25/13 - QT/mc
Edelbrock E-Force Supercharger System for
the 2010-2013 Camaro SS
Installation Instructions
Page 25
153. Use a 10mm deep socket to install the supplied ball
studs into the new coil covers.
154. Install the grommet supplied in Bag #6 in the hole on
the passenger side coil cover.
155. Slide the front fascia back into place and secure it by
reinstalling the stock fasteners, reversing the disassembly
process.
156. Reconnect the fog light electrical connectors and the
fascia wiring harness connector on the passenger side.
157. Use a 10mm socket to reconnect the positive battery
terminal.
158. Use a 10mm socket to reconnect the negative battery
terminal.
159. Remove intercooler reservoir cap and fill intercooler
system with a 50/50 blend of water and coolant.
160. Reconnect petcock and fill the engine coolant system
with a 50/50 blend of water and coolant (if applicable).
161. Reinstall and secure the front inner fender wells with
the stock fasteners.
162. Reinstall the front wheels and snug the lug nuts.
Lower the vehicle to the ground then torque the lug nuts in
a crossing pattern to 100 ft/lbs.
If you have yet to flash your ECU, then proceed with
steps 163 - 176, otherwise disregard them.
163. It is recommended that you check the Edelbrock
website (http://www.edelbrock.com/automotive_new/mc/
superchargers/fuel_injected_soft-tech.shtml) to confirm
that you have the latest calibration. Once you have found
the latest tune on the site, power on the programmer, press
the left arrow and select the Device Info option. Scroll down
to Tune Version and compare that number to the one on the
site. If they are different, download the new calibration with
the supplied USB cable.
164. Turn the key to the On position, but do not start it.
165. Connect the PCM cable from the supplied downloader
to the OBD-II connector located below the steering wheel in
the passenger compartment.
166. Use the directional pad to highlight the Program
Vehicle option and press the Select button.
167. Use the directional pad to highlight the Preprogrammed
Tune option and press the Select button.
168. Read disclaimer then press Select to continue.
169. Verify ignition is in the ‘Key On’ position but that the
engine is not running then press Select.
170. Use directional pad to highlight your vehicle and
transmission combination then press Select.
171. Use directional pad to highlight your vehicle and
transmission combination then press Select, again.
172. Use directional pad to highlight Begin Program then
press Select.