Edelbrock 2010 User Manual
Page 19
©2013 Edelbrock LLC
Part #1596, 1597, 1598, 1599
Brochure #63-1598
Rev. 3/25/13 - QT/mc
Edelbrock E-Force Supercharger System for
the 2010-2013 Camaro SS
Installation Instructions
Page 18
93. Install the water pump to heat exchanger hose on the
passenger side inlet fitting of the heat exchanger and clock
it until it contacts the lower radiator shroud. Secure the
fitting with a 3/4” hose clamp supplied in Bag #2.
94. Slide the strap over the body of the water pump and
install it in the water pump bracket. Rotate the water pump
and slide it in and out until it roughly lines up with the
position of the hose on the other side of the lower radiator
shroud.
95. Use a uni-bit to drill a 1-1/8” hole in the lower radiator
shroud to allow the hose to slide onto the water pump outlet
fitting.
96. Use the supplied bolt and a 13mm socket to secure the
water pump by tightening the strap to the bracket.
97. Slide the hose onto the water pump outlet and secure
it with a 3/4” hose clamp supplied in Bag #2.
98. Install the Intercooler Hose Assembly by sliding it down
between the radiator fan assembly and the engine. Note
that the short hose section will go around the radiator to the
outlet of the heat exchanger.
99. Use a unibit to drill a 1-1/8” hole in the radiator
shroud on the driver side directly across from the heat
exchanger outlet.
100. Slide the short section of the Intercooler Hose
Assembly through the hole and onto the heat exchanger
outlet. Secure it with a 3/4” hose clamp supplied in Bag
#2.