Edelbrock 2010 - Manual (Page 16)

©2013 Edelbrock LLC
Part #1596, 1597, 1598, 1599 Brochure #63-1598
Rev. 3/25/13 - QT/mc
Edelbrock E-Force Supercharger System for
the 2010-2013 Camaro SS
Installation Instructions
Page 15
55. Apply blue Loctite, or equivalent, to the threads of the
M8 x 100mm bolts supplied in Bag #1 then use a 6mm
Allen tool to install the idler bracket onto the water pump.
56. Use a 15mm socket to remove the nut retaining the
ground strap on the passenger side cylinder head then use
a 15mm deep socket to remove the ground strap stud.
57. Apply blue Loctite, or equivalent, to the threads of the
stock tensioner bolts then use a 15mm socket to install the
supplied tensioner bracket to the water pump.
58. Apply blue Loctite, or equivalent, to the threads of the
M10 x 65mm bolt supplied in Bag #1 then use an 8mm
allen to install it in the countersunk bolt hole of the tensioner
bracket.
59. Apply blue Loctite, or equivalent, to the threads of an
M8 x 20mm bolt supplied in Bag #1 then use the supplied
washer and a 12mm socket to install the supplied idler
pulley onto the tensioner bracket.
60. Apply blue Loctite, or equivalent, to the threads of the
M10 x 75mm bolt supplied in Bag #1 then use a 15mm
socket to install the supplied tensioner onto the tensioner
bracket.
61. Use a 12mm socket and an M8 x 20mm bolt supplied
in Bag #1 to secure the ground strap to the back side of the
tensioner bracket.
NOTE: If not already done so, it’s recommended to drain the
coolant by removing the petcock to avoid coolant spillage.
62. Use pliers to loosen the hose clamps and disconnect
the two small upper radiator hoses. Use caution when
removing and reinstalling hoses onto plastic fittings.