Edelbrock 2010 User Manual
Page 25
©2013 Edelbrock LLC
Part #1596, 1597, 1598, 1599
Brochure #63-1598
Rev. 3/25/13 - QT/mc
Edelbrock E-Force Supercharger System for
the 2010-2013 Camaro SS
Installation Instructions
Page 24
145. Connect the stock MAP & MAF sensor wiring harness
connectors into the supplied TMAP wiring harness then
connect the TMAP harness to the MAF sensor.
146. Use a 13mm socket to remove the nut from the power
stud at the front of the fuse box. Slide the ring connector
at the end of the orange wire on the relay harness over the
power stud then reinstall the stock nut.
147. Install the relay on the tab on the passenger side of
the fuse box and the fuse housing on the brace directly in
front of the fuse box using the body pins supplied in Bag #2.
148. Route the intercooler water pump connector attached
to the relay down to the water pump and plug it in.
149. Use a 10mm socket to remove the passenger side
fender bolt, install the ground strap ring connector
underneath it, then reinstall the bolt.
150. Disconnect the stock EVAP solenoid electrical
connector and plug it into the color matched receptacle on
the relay harness.
151. Clip the supplied EVAP solenoid electrical connector
on the relay harness into the EVAP solenoid.
152. Connect the passenger side pcv hose to the fitting on
the passenger side valve cover and carefully route the hose
to the fitting on the underside of the silicone air inlet tube
so as to avoid contact with the serpentine belt or any
pulleys.