Edelbrock 2010 - Manual (Page 27)

©2013 Edelbrock LLC
Part #1596, 1597, 1598, 1599 Brochure #63-1598
Rev. 3/25/13 - QT/mc
Edelbrock E-Force Supercharger System for
the 2010-2013 Camaro SS
Installation Instructions
Page 26
173. Vehicles equipped with a manual transmission will
have three separate operations take place during this step,
while vehicles with an automatic transmission will have
five. Completion of each operation will cause the progress
bar to reset to zero.
DO NOT unplug the programmer until prompted.
174. Turn the car off when prompted to do so by the
handheld programmer.
175. Read parting message from programmer then press
Select to continue.
176. Unplug the programmer cable from the OBD-II port.
177. Start the car and allow it to idle while closely
inspecting the engine bay for any fuel or coolant leaks.
Repair any leaks before operating vehicle!
178. Remove the engine oil dipstick.
179. Lubricate the grommet on the passenger side coil
cover then install it by sliding the grommet down and
around the dipstick tube and pressing the ball studs into the
bracket grommets.
180. Return the dipstick to the dipstick tube.
181. Install the driver side coil cover by sliding it into place
and pressing the ball studs into bracket grommets.
Congratulations on the installation of your new Edelbrock
E-Force Supercharger System. If you have any questions,
please call our Technical Support hotline and one of our
technicians will be happy to assist you.