Edelbrock 2010 User Manual
Page 15
©2013 Edelbrock LLC
Part #1596, 1597, 1598, 1599
Brochure #63-1598
Rev. 3/25/13 - QT/mc
Edelbrock E-Force Supercharger System for
the 2010-2013 Camaro SS
Installation Instructions
Page 14
47. Apply thread sealant to the threads of the oil pressure
sensor then use a crescent wrench to install the sensor in
the new valley plate. Reconnect the oil pressure sensor
electrical connector.
48. Use a 15mm socket to remove the two bolts retaining
the belt tensioner.
NOTE: Steps 49-52 will demonstrate how to install the
Edelbrock heater hoses included with this kit. This
procedure is optional on 2013 model years as the factory
heater hoses are adequate.
49. Place a drain pan below the radiator petcock on the
driver side. Remove the radiator cap then loosen the
petcock to drain the engine coolant.
50. Disconnect the two heater hoses from the firewall using
a shop rag to absorb any excess coolant.
51. Disconnect the two heater hoses from the water pump
using a shop rag to absorb any excess coolant.
52. Install the supplied Heater Core Hose Assembly to the
firewall fittings using the supplied hose clamps. Route the
lines between the engine oil dipstick and the fuse box to the
fittings on the water pump and secure them with the
supplied hose clamps. Note that the hose closer to the
passenger side of the firewall will be routed to the fitting
closer to the front of the vehicle and vice versa.
53. Apply Blue Loctite, or equivalent, to the threads of the
M8 x 20mm bolt supplied in Bag #1 then use a 12mm
socket and washer to install the smaller supplied idler pulley
onto the supplied idler bracket.
54. Use a 10mm socket to remove the three water pump
bolts indicated.