Edelbrock 2010 - Manual (Page 18)

©2013 Edelbrock LLC
Part #1596, 1597, 1598, 1599 Brochure #63-1598
Rev. 3/25/13 - QT/mc
Edelbrock E-Force Supercharger System for
the 2010-2013 Camaro SS
Installation Instructions
Page 17
82. Lift the starter support bracket and starter into place
then use a 13mm wrench to reinstall the power wire onto
the starter.
83. Reconnect the starter solenoid electrical connector.
84. Use an 8mm wrench to reinstall the three bolts that
hold the starter heat shield in place.
85. Use a 13mm socket to install the two starter bolts.
86. Use a 10mm socket to reinstall the starter support
bracket bolt.
87. Lower the fan assembly back into place, reconnect
the passenger side electrical connector then use a 13mm
socket to reinstall the stock fan assembly bolt on the driver
side only, the passenger side will be installed later.
88. Use a panel puller to remove the two body pins from the
top of the lower radiator shroud.
NOTE: Convertible models are equipped with a brace that
connects the frame extensions, this brace will need to
be removed and replaced with the Edelbrock Convertible
Brace (Part #15956, Sold Separately) as it interferes with
the installation of the Edelbrock heat exchanger.
89. Install the supplied heat exchanger behind the bumper
so that the lower bracket holes line up with those in the
radiator shroud.
90. Secure the top of the heat exchanger with the two M8
x 20mm bolts supplied in Bag #2 and tighten them with a
12mm socket.
91. Install the M8 nuts and M8 x 20mm bolts supplied in
Bag #2 into the holes in the lower heat exchanger brackets
then use a 12mm wrench and socket to tighten them.
92. Install the intercooler water pump bracket on the studs
located on the back of the passenger side of the bumper.
Secure it in place with the M8 nuts supplied in Bag #2 and
tighten them with a 12mm wrench.