Edelbrock 2010 - Manual (Page 12)

©2013 Edelbrock LLC
Part #1596, 1597, 1598, 1599 Brochure #63-1598
Rev. 3/25/13 - QT/mc
Edelbrock E-Force Supercharger System for
the 2010-2013 Camaro SS
Installation Instructions
Page 11
18. Push down the white tab on the front EVAP hose fittings
and disconnect them from the manifold and the EVAP
solenoid.
19. Disconnect the Manifold Air Pressure sensor and EVAP
solenoid electrical connectors.
NOTE: 2013 model years disregard Step 20 and proceed
to Step 21.
20. Disconnect the PCV tube from the engine valley cover.
NOTE: Step 21 only pertains to 2013 model years. Please
disregard otherwise.
21. Remove the driver side PCV on the rear of the diverside
valve cover and on the passenger side of the throttle body.
22. Use a 3/8” Fuel Line Removal Tool to disconnect the
fuel line from the fuel rails and from the passenger side
fender fitting. Use a shop rag to absorb any excess fuel.
23. Use a 10mm socket to remove the nut holding down
the fuel line clamp then remove the fuel line and clamp.
24. Disconnect the two ignition harness connectors, the
eight spark plug wires from the ignition coils and the eight
fuel injector electrical connectors.
25. Use a 10mm deep socket to remove the five studs
retaining each of the ignition coil brackets to the valve
covers. Lift and remove the coil brackets as an assembly.
26. Disconnect the EVAP hose from the EVAP Solenoid and
the passenger side fender fitting.