Edelbrock 2010 User Manual
Page 24
©2013 Edelbrock LLC
Part #1596, 1597, 1598, 1599
Brochure #63-1598
Rev. 3/25/13 - QT/mc
Edelbrock E-Force Supercharger System for
the 2010-2013 Camaro SS
Installation Instructions
Page 23
133. Install the Passenger Side Manifold to Intercooler
Reservoir Hose between the manifold and reservoir then
secure the reservoir fitting with a hose clamp supplied in
Bag #2. Refer to figure 4 on page 20.
134. Install Driver Side Manifold to Intercooler Reservoir
Hose between the manifold and reservoir then secure the
reservoir fitting with a hose clamp supplied in Bag #2.
Refer to figure 4 on page 20.
135. Connect the Intercooler Hose Assembly to the rear
facing driver side fitting and the side facing passenger side
fitting. Push each hose end on until it clicks into place.
136. Use a 16mm wrench to install the coil cover standoffs
on the valve covers.
137. Install the factory throttle body O-ring into the
machined groove on the supercharger air inlet.
138. Use a 10mm socket, the four stock bolts and the stock
O-ring gasket to install the throttle body on the supercharger
air inlet flange.
139. Route the TMAP wiring harness below the supercharger
hub snout towards the driver side using care to secure it
well away from the serpentine belt.
140. Connect the throttle body connector extension harness
to the stock throttle body connector and route the extension
harness so that it will clear the serpentine belt and connect
it to the throttle body connector on the throttle body.
141. Use a T20 Torx bit to remove the MAF sensor from
the stock air box cover and install it in the supplied air box
cover. The arrow on the side of the sensor should point
back towards the supercharger.
142. Replace the stock air filter with the one supplied.
143. Slide the supplied worm clamps over each end of the
supplied silicone tube then slide the tube onto the outlet of
the supplied air box cover. Install the cover by sliding the
tabs into the holes on the driver side of the air box while
sliding the silicone tube onto the throttle body. Push down
on the cover until the tabs snap into place.
144. Use a flathead screwdriver to tighten the worm
clamps on each end of the silicone tube.