TA Triumph-Adler P-C3570DN - Manual (Page 166)

Using the Operation Panel 4-93
1
In the Timer Setting menu, press  or  to select Sleep Level
Set..
2
Press [OK]. The Sleep Level Set. menu screen appears.
Sleep Level (Sleep level setting)
There are two sleep modes with different levels of sleep: Quick Recovery
and Energy Saver.
Quick Recovery Mode: The recovery from the sleep mode is faster than
when using Energy Saver mode.
Energy Saver Mode: This makes it possible to reduce energy
consumption even further than with Quick Recovery mode. With Energy
Saver mode, you can set whether to enable the Energy Saver mode for
each separate function.
1
In the Sleep Level Set. menu, press  or  to select Sleep Level.
2
Press [OK]. The Sleep Level screen appears.
3
Press  or  to select Quick Recovery or Energy Saver.
4
Press [OK]. The sleep level is set and the Sleep Level Set.
menu reappears.
Network (Setting for entering energy-saving mode when
connected to a network)
This sets whether or not the machine enters Energy Saver mode when
connected to a network.
1
In the Sleep Level Set. menu, press  or  to select Status.
2
Press [OK]. The Status menu screen appears.
Note For information on the Quick Recovery mode and Energy
Saver mode, refer to Energy Saver Function on page 2-26.
Sleep Level Set. menu is not displayed when the optional network
interface kit (IB-50) or wireless network interface kit (IB-51) has
been installed.
Sleep Level Set.: a b
1 Sleep Level
2 Status
[ Exit ]
Sleep Level: a b
1 Quick Recovery
2 *Energy Saver
Note Status is only displayed when Energy Saver is set.
Sleep Level Set.: a b
1 Sleep Level
2 Status
[ Exit ]
Status: a b
1 Network
[ Exit ]