TA Triumph-Adler CX 8682 - Manual (Page 59)

7-1
CHAPTER 7 MANAGEMENT AND SETTING
The values selected when the main power switch of this machine is turned on ( ❘ ) or when the Reset key is pressed (default) can be changed.
Change each setting as needed.
The default setting items are classified into “Machine default” concerning the operation of this machine and “Copy default” concerning copy condi-
tions selected with priority depending on the details. Also these are classified based on the authorization into “User” for which settings are restricted
and “Manager” for which all settings can be accessed. To change the default setting with “Manager” authorization, a password must be entered. For
each setting, see “List of Default Setting”.
1. List of Default Setting
(1) Machine default
● Items common to user/manager
Setting item Details Selectable values Default Page
1 Paper width
adjustment
If this item is set to “Input width(# key)”, a non-standard paper width
can be set. Use the numeric keys to enter the paper width for each
paper source.
If a non-standard paper width is entered, the APS function cannot be
used. For each paper source
Auto/Input width 8.5" to
36.2"(210 mm to 920
mm) Auto
2 Paper working If this item is set to “ON”, a paper material can be registered for each
paper source. Fixing temperature, copy size, and fix/unfix of roll end
will be set based on the registered paper material. ON/OFF OFF
3 Paper material
adjustment
If “Paper working” is set to “ON”, a paper material can be set for each
paper source including the bypass table.
If “Custom” is selected, fixing temperature, copy size, etc. will be set
based on “
@ Custom paper adj.” [“Custom paper material adj.”].
For each paper source
Plain/ vellum/ film/
custom Plain
4 Roll end adjust-
ment
Whether paper roll end is fixed to the core of the roll or not is set. If
“Fix” is selected, paper will be automatically cut when paper runs out. For each paper material
Fix/Unfix Unfix
(Fix for
film)
5 Display contrast Liquid crystal display on the operation panel is adjusted. 1 to 7 4
6 Orig.eject direct If this item is set to “Discharge to front” [“Output to front”], finished
originals will return to the front side.
If this item is set to “Discharge to back” [“Output to back”], originals
will be ejected to the rear side of the machine. Front/rear Rear
7-10
7-11
7-11
7-11
7-12
7-12