TA Triumph-Adler CX 8682 - Manual (Page 88)

CHAPTER 8 TROUBLESHOOTING
8-6
(Inch)
(Metric)
(Inch)
(Metric)
1
2
(Inch)
(Metric)
4. Countermeasures against Memory Overflow
This machine stores image data in memory and then performs
copying. Since the memory capacity is limited, memory overflow may
occur during copying and the following messages may appear.
If “ ( Memory compress” of the default setting is set to “Standard-
compression “ [“Standard”]” from Non-compression” or to “High-
compression “ [“Condensation”] from “Standard-compression “
[“Standard”]”, the image data capacity in the memory can be in-
creased. If the compression ratio is set to a higher level, however,
halftone (gray) images may be deteriorated. (Page 7-6)
* If memory overflow occurs frequently, addition of memory is
recommended. Contact a dealer of our products.
If the message “Could not be saved.” appears:
This message may appear when copying is performed while the
original is being scanned in normal copying. The overall image data
could not be saved in memory.
If the number of copies is more than 1, only one copy will be output.
Repeat copy is not possible.
If the message “Memory full” appears:
This message may appear when scanning of original is performed
before copying for using the sort copy, editing functions, job reserve
or interrupt copy.
If memory overflow has occurred in job reserve or interrupt copy, wait
until the current output is complete. If memory overflow has occurred
in sort copy, reduce the number of originals.
Press the OK key. A selection screen for original ejection
direction will appear.
Press the ▼ or ▲ key to select the original ejection direction.