TA Triumph-Adler DC 2020 - Manual (Page 34)

CHAPTER 5 FUNCTIONS
Press the Start key.
If originals are set in the DF, all originals are scanned one by
one and copying performed accordingly.
If setting originals on the platen, go to the next step.
Replace the original and press the Start key. Scanning of the
originals will start. Carry out the same procedures to the
originals of which copying will be performed, and finally,
press the enter key. Copying will start.
Press the Layout key to light the indicator.
The layout copy setting screen will appear.
Press the cursor down or up key to select the layout copy
mode.
In the “4-UP” mode, when setting originals horizontally, select
“4-UP (Z)”; when setting originals vertically, select “4-UP (N)”.
Press the enter key.
Press the cursor down or up key to select the type of the
borderline.
Select from “DOTTED” or “SOLID”.
Press the enter key.
The message display will return to the “READY TO COPY.”
screen.
Set the original(s).
IMPORTANT
• Before setting original on the platen, make sure they are in a
sequence that produces images in the numbered positions.
• Select the paper according to the situation.
1
2
3
4
5
6
7
8
5-8