TA Triumph-Adler DC 2020 - Manual (Page 61)

CHAPTER 8 WHEN A PROBLEM OCCURS
8-2
8-3
8-6
"TIME FOR MAINTENANCE" Periodic maintenance is necessary to keep your copier in good condition.
Contact your service representative as soon as possible.
"MEMORY IS FULL." The copier memory if full. Either print out or clear all scanned data. It is not
possible to copy or scan another original until one of these two operations is
performed.
"PAPER MISFEED." If paper is misfed, the copier will stop and the location of the misfeed will
appear on the message display. Remove the misfed paper with the main switch
turned ON (|) by following the appropriate procedure.
"REMOVE ORIGINAL FROM FEEDER."
"MISFEED IN FEEDER. REMOVE
ORIGINAL(S)." Originals have not been fed correctly from the DF (optional). Remove the
originals with the main switch turned ON (|) by following the appropriate
procedure.
"DUPLEX UNIT IS OUT OF ORDER. 1-SIDED
COPYING IS POSSIBLE." The duplex unit (optional) is out of order and duplex copying is not possible.
Contact your service representative immediately.
"INSTALL FINISHER." The finisher (optional) is not installed correctly. Install it securely.
"CHECK PAPER IN FINISHER. INCOM-
PLETE COPIES INSIDE." Unfinished copies were ejected onto the finisher (optional) due to a problem
occurred during copying. Check and remove those copies.
"FINISHER IS OUT OF ORDER. DETACH
FINISHER." The copier is inoperable due to a problem in the finisher (optional). Contact
your service representative immediately.
"PAPER CAPACITY EXCEEDED. REMOVE
PAPER FROM FINISHER." The number of sheets in the finisher (optional) exceeded the capacity. Remove
the excess sheets.
"REMOVE PAPER FROM INNER TRAY OF
FINISHER." Paper has been misfed inside the finisher (optional). See the finisher's
instruction handbook and remove the paper.
"REMOVE PAPER FROM SUB TRAY OF
FINISHER." Paper has been misfed at the sub-tray of the finisher (optional). See the
finisher's instruction handbook and remove the paper.
"STAPLER EMPTY. ADD STAPLES." There are no staples in the finisher (optional). See the finisher's instruction
handbook and replace the staple cartridge.
"CANNOT STAPLE THIS PAPER SIZE." Stapling is not possible with small size paper. For details, see the finisher's
instruction handbook.
Message Action Page