TA Triumph-Adler DC 2020 - Manual (Page 60)

8-1
3-1
6-1
3-5
3-5
CHAPTER 8 WHEN A PROBLEM OCCURS
1. Error messages
When any of the messages listed in the table below appear on the message display, take the corrective action as instructed.
"CLOSE xxx COVER." The cover indicated is open. Close the cover securely.
"ADD PAPER IN DRAWER." There is no paper in the drawer indicated. Load paper.
"CLOSE PAPER DRAWER." One of the drawers is not closed properly. Pull it out and push it back in all the
way.
"PAPER DRAWER IS OUT OF ORDER.
SELECT OTHER PAPER DRAWER." The drawer currently in use is out of order and cannot be used. Contact your
service representative immediately. Continue copying using another drawer.
"CHECK PAPER SIZE." No paper that can be used in the selected mode is loaded. Check the paper.
"REPOSITION ORIGINAL OR SELECT
OTHER PAPER DRAWER." The orientation of the original and the selected paper are different. Change the
orientation of the original. If the Start key is pressed, same-size copying will be
performed.
"COPY LIMIT REACHED. NO COPYING" The number of copies reached the limit set in the copy management mode and
no more copies can be made. Clear the copy count from the management
mode.
"READY TO COPY.
ADD TONER TO RESUME COPYING." There is not enough toner in the copier. Replace the toner cartridge immedi-
ately as only one copy can be made at a time.
"ADD TONER TO RESUME COPYING." There is not enough toner in the copier to make copies. Replace the toner
cartridge immediately.
"CALL FOR SERVICE." Open and close the front cover. If the same message appears again, make a
note of the "C" and the number appearing with it, turn the main switch OFF (O),
and contact your service representative.
Message Action Page