TA Triumph-Adler DC 2020 - Manual (Page 53)

CHAPTER 6 COPIER MANAGEMENT
5 PAPER TYPE (1ST to 4TH)
Press the cursor down or up key to select the paper type.
Press the enter key.
NOTE
• The setting procedure for the paper type is the same for Drawers 1,
2, 3 and 4.
6 PAPER TYPE (BYPASS)
Press the cursor down or up key to select the paper type.
Press the enter key.
7 SELECT EJECTOR OF FAX
The optional fax board and job separator must be installed to perform
this setting. If not, this setting will not be displayed.
3 SPECIAL PAPER
Press the cursor down or up key to select the paper feed
drawer to be marked with (
* ).
Press the cursor right or left key. The mark ( * ) will appear
aside the paper feed drawer. Press the cursor right or left key
again to cancel it.
NOTE
• More than two marks can be put.
Press the cursor up key to select “END” and press the enter
key.
4 APS
Press the cursor down or up key to select “ON” or “OFF”.
Press the enter key.
1
2
1
2
3
1
2
1
2
6-17