1chapter 7 optional equipment – TA Triumph-Adler DC 2020 User Manual
Page 56
7-1
1
CHAPTER 7 OPTIONAL EQUIPMENT
(1) ADF (Automatic document feeder)
Automatically feeds multiple sheet originals one by one for scanning.
1
1
1
1
1 Originals that can be used with the DF
• Sheet originals only
• Original weights: Single-sided original of 35 g/m
2
to 160 g/m
2
• Original sizes: 11" x 17"/A3 (maximum) to 5 1/2" x 8 1/2" (vertical)/
A5R (minimum)
• Capacity: 70 sheets (11" x 8 1/2"/A4 and smaller, 75 g/m
2
or
80 g/m
2
)
50 sheets (8 1/2" x 14"/B4 and larger, 75 g/m
2
or 80 g/m
2
)
50 sheets in auto selection mode
2
2
2
2
2 Precautions for the use of DF
Do not use any of the originals given below with the DF. Also do not
set originals with punch holes or tear-off strips positioned at the
leading edge.
• Transparency films
• Carbon paper and extremely creased or folded originals, originals
of soft material such as vinyl
• Non-square originals, wet originals, originals with adhesive tape or
glue
• Originals bundled with a paper clip or staple (if inevitable, remove
the paper clip or staple and straighten out the creases and folds
before setting the originals)
• Clipped out originals, originals with slippery surface
• Originals with still-wet whiteout
• Originals with creases (if inevitable, straighten out the creases
before setting the originals)
3
3
3
3
3 DF part names
1 Original table
(Place the originals here.)
2 Original insertion guides
(Adjust the guides to the width of the originals.)
3 DF open/close handle
(Hold this handle when opening and closing the DF.)
4 Original eject cover
(Copied originals are stored here.)
5 DF original cover
(Open this cover to remove an original misfed in the DF.)
4
4
4
4
4 How to set originals in the DF
Adjust the original insertion guides to the original size.
NOTE
• Before setting the originals in the DF, check that no original from the
previous operation is remaining on the original eject cover. Originals
remaining on the original eject cover may cause original misfeed.