TA Triumph-Adler DC 2325 - Manual (Page 102)

Sending Functions
2-28 ADVANCED OPERATION GUIDE
Individual Border Erase
Specify border erase widths individually for all edges.
In each option, the available ranges are as below.
Use the procedure below to erase borders when sending scanned
originals.
1 Place the originals on the platen.
2 Press the Send key.
3 Press [Advanced Setup] and then [Border Erase].
4 Press [Border Erase Sheet] to erase borders for an individual sheet or
[Border Erase Book] to erase borders for a book.
Use [+] or [-] to enter
the width in Border
or Gutter. Press [#
Keys] to use the
number keys for
entry.
Press [Individual Border Erase] to select the individual border erase.
Use [+] or [-] to enter the border width or press [# Keys] and enter the width
using the numeric keys.
Input units Border Erase Range
Inch models 0 to 2" (in 0.01" increments)
Metric models 0 mm to 50 mm (in 1-mm increments)
Original Copy
Status 10/10/2007 10:10
Enter Destination.
Cancel OK Add Shortcut
Ready to send.
Border Erase
Sheet
Border Erase
Book
Off
Individual
Border Erase
Border
Border Erase
Destination
Gutter
"
"
# Keys
# Keys
(0.00 - 2.00)
(0.00 - 2.00)
Press [OK] to display
1
0.00
0.00
the image.