TA Triumph-Adler DC 2325 - Manual (Page 98)

Sending Functions
2-24 ADVANCED OPERATION GUIDE
Background Density Adjustment
Lightens the background of the colored original when it is too dark.
NOTE: You cannot adjust the background density if you selected
[Monochrome] in Color Selection (see page 2-25).
Use the procedure below to set the background density when sending
scanned images.
1 Place the originals on the platen.
2 Press the Send key.
3 Press [Color/Image] and then [Background Density Adj.].
4 Press [On], and
press [1] to [5]
(Lighter- Darker) to
adjust the density.
5 Press [OK].
6 Specify the destination, and press the Start key to start sending.
Status 10/10/2007 10:10
Place original .
Cancel OK Add Shortcut
Ready to send.
On
Off Background
Background Density Adj.
Lighter
1 2 3 4 5
Darker
1
Press [OK] to display
Destination
the image.