PLANET WGS3-24000 - Manual (Page 444)

444
12.5.1 ip vrrp (Global Config)
Use this command in Global Config mode to enable the administrative mode of VRRP on the router. Default none
▫ Format ip vrrp
▫ Mode Global Config
12.5.1.1 no ip vrrp
Use this command in Global Config mode to disable the default administrative mode of VRRP on the router.
▫ Format no ip vrrp
Mode Global Config
12.5.2 ip vrrp (Interface Config)
Use this command in Interface Config mode to create a virtual router associated with the interface. The parameter <vrid>is the
virtual router ID , which has an integer value range from 1 to 255.
▫ Format ip vrrp <vrid>
▫ Mode Interface Config
12.5.2.1 no ip vrrp
Use this command in Interface Config mode to delete the virtual router associated with the interface. The virtual Router ID,
<vrid>, is an integer value that ranges from 1 to 255.
▫ Format no ip vrrp <vrid>
▫ Mode Interface Config
12.5.3 ip vrrp mode
This command enables the virtual router configured on the specified interface. Enabling the status field starts a virtual router.
The parameter <vrid> is the virtual router ID which has an integer value ranging from 1 to 255.
▫ Default disabled
▫ Format ip vrrp <vrid> mode
▫ Mode Interface Config
12.5.3.1 no ip vrrp mode
This command disables the virtual router configured on the specified interface. Disabling the status field stops a virtual router.
▫ Format no ip vrrp <vrid> mode
▫ Mode Interface Config
12.5.4 ip vrrp ip
This command sets the virtual router IP address value for an interface. The value for <ipaddr> is the IP address which is to be
configured on that interface for VRRP. The parameter <vrid> is the virtual router ID which has an integer value range from 1 to