PLANET WGS3-24000 - Manual (Page 481)

481
▫ Mode Interface Config
no ip rip receive version
This command configures the interface to allow RIP control packets of the default version(s) to be
received.
▫ Format no ip rip receive version
▫ Mode Interface Config
12.8.11 ip rip send version
This command configures the interface to allow RIP control packets of the specified version to be sent.
The value for <mode> is one of: rip1 to broadcast RIP version 1 formatted packets, rip1c (RIP version 1 compatibility mode)
which sends RIP version 2 formatted packets via broadcast, rip2 for sending RIP version 2 using multicast, or none to not allow
any RIP control packets to be sent.
▫ Default rip2
▫ Format ip rip send version {rip1 | rip1c | rip2 | none}
▫ Mode Interface Config
no ip rip send version
This command configures the interface to allow RIP control packets of the default version to be sent.
▫ Format no ip rip send version
▫ Mode Interface Config
12.8.12 hostroutesaccept
This command enables the RIP hostroutesaccept mode.
▫ Default enabled
▫ Format hostroutesaccept
▫ Mode Router RIP Config
no hostroutesaccept
This command disables the RIP hostroutesaccept mode.
▫ Format no hostroutesaccept
▫ Mode Router RIP Config
12.8.13 split-horizon
This command sets the RIP split horizon mode. Split horizon is a technique for avoiding problems caused by including routes in
updates sent to the router from which the route was originally learned. The options are: None - no special processing for this