PLANET WGS3-24000 - Manual (Page 510)

510
13.5 Protocol Independent Multicast - Sparse Mode(PIM-SM) Commands
This section provides a detailed explanation of the PIM-SM commands. The commands are divided into the following different
groups:
◆Show commands are used to display device settings, statistics and other information.
◆Configuration commands are used to configure features and options of the switch. For every configuration command there is
a show command that will display the configuration setting.
13.5.1 ip pimsm cbsrpreference
This command is used to configure the CBSR preference for a particular PIM-SM interface. The range of CBSR preference
is –1 to 255.
▫ Default 0
▫ Format ip pimsm cbsrpreference <-1-255>
▫ Mode Interface Config
no ip pimsm cbsrpreference
This command is used to reset the CBSR preference for a particular PIM-SM interface to the default value.
▫ Format no ip pimsm cbsrpreference
▫ Mode Interface Config
13.5.2 ip pimsm cbsrhashmasklength
This command is used to configure the CBSR hash mask length to be advertised in bootstrap messages for a particular PIM-SM
interface. This hash mask length will be used in the hash algorithm for selecting the RP for a particular group. The valid range is
0 - 32. The default value is 30.
▫ Default 30
▫ Format ip pimsm cbsrhashmasklength <0-32>
▫ Mode Interface Config
no ip pimsm cbsrhashmasklength
This command is used to reset the CBSR hash mask length for a particular PIM-SM interface to the default value.
▫ Format no ip pimsm cbsrhashmasklength
▫ Mode Interface Config
13.5.3 ip pimsm crppreference
This command is used to configure the Candidate Rendezvous Point (CRP) for a particular PIM-SM interface. The valid values