PLANET ISW-504PS - Manual (Page 50)

User’s Manual
4.5.1 VLAN Group
The VLAN Group page contains fields for managing VLAN mode of the Industrial PoE Switch and setting ports that are part
of a VLAN. The port default VLAN ID (PVID) is configured on the VLAN Port Configuration page. All untagged packets
arriving to the device are tagged by the ports PVID. As shown in
Figure 4-27 & 4-28 .
The VLAN mode had three modes:
■ Disable (No VLAN)
■ Port-Based VLAN
■ 802.1Q VLAN
The Industrial PoE Switch supports Port-based VLAN and 802.1Q VLAN (Tagged-based) in Web management page. In
the default configuration, VLAN support is “Disable”.
Figure 4-27 VLAN Group screenshot
4.5.1.1 Port-Based VLAN
By setting the VLAN Type with Port-Based, Port-Based VLAN is enabled and 802.1Q VLAN tagging is ignored. The VLAN
group classification of an incoming packet on a Port-Based VLAN is defined by the VLAN group table.
A port is limited to communicate with other ports within the same group when the function is enabled and configured.
Frame will be limited in a VLAN group and will not be forwarded out this VLAN group. A port can be assigned to one or
more VLAN groups.
-50 -