HP 24SII - Manual (Page 126)


APPENDIX B
MODEL 24SII MODULE INSTALLATION
B.1 MODEL 24SII I/O MODULE
INSTALLATION
Each I/O module provided by BayTech includes one of the following
L-shaped modules:
 (* & +#  +
%$#
,!--./
   #  #00 0 # & .  '0
,!--./
   #   0 1-2. &%1 # & . '0
,!--./
   #   0 1-2. & 1 # & .  '0
,!--./
2   #   0 1-2. '0 # 3.
,!--./
   #   0 1-2. '0 # 3.
,!--./
   #   0 +  0# # & . '0
You will need the following equipment:
1 x straight-slot screwdriver
1 x phillips-head screwdriver
1. IMPORTANT: Remove power from the unit by depressing the
power switch on the front of the unit to OFF and also remove
power cord from socket.
2. I/O modules must be installed in sequence from left to right
(facing rear of unit). There can be no empty slots between
modules. For example, if I/O modules are currently installed in
the first three module slots, the new module must be installed
in the 4th module slot. The module slots are labeled on the top
panel as "Module 1", "Module 2", ..., "Module 6".