HP 24SII - Manual (Page 78)


&
  

 
OPTION ACCESSIBILITY: Through any serial computer port.
The Model 24SII DES will respond to the receiving of Control-T ,
capital C, and the desired module number with an identification block
and a menu of the configuration options available, similar to the
following:
Copyright (c) Bay Technical Associates, 1992
Model 24SII Data Exchange System Rev. 2.02
Total memory 1M
This Module is 1
Status.......................................1
Program Port Logical Name....................2
Set Port Designation.........................3
Program Port Select Code.....................4
Set Port Select Mode.........................5
Set Serial Port Configuration................6
Set Input Inactivity Timeout.................7
Enable/Disable Form Feed Mode................8
Program I.D. Page Message....................9
Enable/Disable I.D. Page Message.............A
Select Print Schedule for I.D. Page..........B
Program Default Printer Assignment...........C
Program Module Printer Sharing Mode..........D
Exit Configuration...........................X
For illustration purposes, we will show the configuration menus for
Module 1 which are typical of the configuration menus generated by
other modules.
NOTE: Menu selection is case sensitive. It is recommended that your
keyboard be in the CAPS LOCK position.
NOTE: If you have configured a module and exited from
configuration mode for that module, you must wait for the Model 24SII
DES to reset before attempting to access configuration mode for
another module. It takes the Model 24SII DES 5 to 10 seconds to
reset after exiting configuration mode for a module. The LEDs on the
front panel will illuminate while the Model 24SII DES is resetting. Wait
for the LEDs to go out before attempting to configure another module.