HP 24SII - Manual (Page 89)


------------------------------------------
| Port | Logical Name |Timeout| Port |
| | (Computer) |in sec |Sel Mode|
------------------------------------------
| 1 |Device A | 20 |Anytime |
| 3 |Device C | 20 |Begin |
| 4 |Device D | 20 |Anytime |
------------------------------------------
Enter Port Number (ENTER=Exit) :
You may now proceed to set the Port Select Mode for another port, or
exit by striking the Enter key. The Model 24SII DES will save the new
Port Select Mode permanently in non-volatile memory and will
subsequently power-up with the new Port Select Mode in effect.
The Model 24SII DES will now return to the main configuration menu
(see
Section 8.1 ).
&& 
  
 


NOTE: This section does not pertain to the M24SII-V02 high speed
parallel module since there are no serial ports on this module.
OPTION ACCESSIBILITY: Through any serial computer port.
By responding to the Enter Request: message at the end of the main
configuration menu (see
Section 8.1 ) with "6" (Set Serial Port
Configuration), you may change the serial configuration of each serial
port on the selected module, i.e. baud rate, word size, stop bits, parity,
and XON/XOFF handshaking (Transmit and Receive). High speed
serial modules also allow you to program the Printer Sharing Mode.
The M24SII-V07 high speed serial module will allow you to program
the 4-Wire/8-Wire Operation.
Each port is configured individually. This allows the user to mix-and-
match devices of different configurations without the need to
reconfigure the devices. It also allows the Model 24SII DES to
translate for devices using different configurations.