HP 24SII User Manual

Page 149

Advertising
background image



PROBLEM

SYMPTOM

CAUSE

SOLUTION

check pin 20 of peripheral to pin 5 of
Model 24SII DES and/or pin 11 on
parallel ports for continuity by using an
ohm meter to check resistance from end
to end.

Parallel cable
length

Parallel cable should not exceed 15 feet.
Use shorter length or higher-quality
cable.

Configuration
problem

Check baud rate, word size, stop bits
and parity on serial ports. It is best to be
at 8 word size and no parity. BayTech
does not recommend a configuration of
7 word size with odd or even parity.

Random
Garbage
Characters

Serial Port
Configuration

In Model 24SII DES configuration mode,
match baud rates, word size, stop bits,
parity and handshaking with the conned
device

Cable length

If serial cable, length should not exceed
150 feet. If parallel cable, length should
not exceed 15 feet.

Cannot select
printer

Incorrect LEDs
illuminate when
sending print
job

Port selection

Port Select Code may be going out on
wrong port; e.g. Port Select Code is
going out LPT1 and Model 24SII DES is
connected to COM1. Also make sure
selected port is designated as a printer
port and not as a computer port.

Improper Port
Select
Sequence

Match Port Select Code you are sending
to Port Select Code specified in
configuration mode. Check case of Port
Select Code (upper or lower). Also,
remove any spaces between Port Select
Code and port number.

You are in
Port Select
Mode B with
zero (0)
timeout

Switch to Port Select Mode A or enter a
timeout value, both via configuration
mode.

Some sort of
Port Select
code prints on
document when
using
RAMEXEC

Port Select
Code in
SETUP does
not match
Port Select
Code
configured in
Model 24SII
DES

Match the Port Select Codes exactly.

Cannot select
Printer during
print job

You are using
Port Select
Mode B (port
selection at
beginning of
print job only)

Switch to Port Select Mode A in
configuration (port selection anytime
while sending) or wait for computer LED
to go out before selecting printer.

RAMEXEC

Have to reboot

LPTx not

Reroute LPTx using the following DOS

Advertising