HP 24SII - Manual (Page 90)


CAUTION: If you have a M24SII-V07 installed as Module 1, do not
configure Port 1 of this module for any baud rate higher than 115,200
or you will locked out of configuration mode and unable to program
the various features of the Model 24SII.
The Model 24SII DES will respond with:
Enter Request :6
Bidirectional
---------------------------------------------------
| Port | Baud | Word | Stop |Parity| Xon / Xoff |
| | Rate | Size | Bits | | Xmit | Recv |
---------------------------------------------------
| 1 | 9600| 8 | 1 |None | Off | Off |
| 2 | 9600| 8 | 1 |None | Off | Off |
| 3 | 9600| 8 | 1 |None | Off | Off |
| 4 | 9600| 8 | 1 |None | Off | Off |
--------------------------------------------------
Enter Port Number (ENTER=Exit) :
You should enter the number of the port that you wish to reconfigure,
and then strike the Enter key. For example, if you sent "2" and Enter,
the Model 24SII DES will respond with the current status of Port 2 and
a menu of the available options:
Bidirectional
---------------------------------------------------
| Port | Baud | Word | Stop |Parity| Xon / Xoff |
| | Rate | Size | Bits | | Xmit | Recv |
---------------------------------------------------
| 2 | 9600| 8 | 1 |None | Off | Off |
--------------------------------------------------
Exit/Save......1 Set Stop Bits.....4
Set Baud Rate..2 Set Parity........5
Set Word Size..3 Set XON/XOFF......6
Enter Request :
You may now reconfigure Port 2 by selecting the appropriate option
(1-6) from the menu.
NOTE: The M24SII-V07 module will also show Set 4-Wire/8-Wire as
item number 7 .