Appendix a.7.2 – HP 24SII User Manual
Page 47
NOTE: Ports using this configuration will support XON/XOFF
handshaking only. You must enable XON/XOFF handshaking in
configuration mode for these ports (see
Section 8.8.1
) and on the
equipment that will connect to these ports.
Ports on the M24SII-V07 module using EIA-232 Protocol, 4-wire
Operation, and bidirectional Printer Sharing Mode utilize the following
pins and signals for communication:
RJ-11 PIN-OUT INFORMATION
PIN
SIGNAL
EIA-232
DIRECTION
DESCRIPTION
1
NC
----
No connection
2
TX
Output
Transmit Data
3
RX
Input
Receive Data
4
GND
----
Signal Ground
If you are connecting a device to a port on the M24SII-V07 module
using EIA-232 Protocol, 4-wire Operation, and bidirectional Printer
Sharing Mode, please see
Appendix A.7.2
for device adapter pinouts
and recommended cabling.