Honeywell INTELLIKNIGHT 5820XL - Manual (Page 166)

IntelliKnight 5820XL Installation Manual
7-40 151209
60 Hz. selection
To change the AC line frequency, continue programming from step 9 above:
10. Select 50, 60 or Neither, by pressing the or arrow, then press .
7.7.5 Miscellaneous Options 2
Through this programming option you can turn the strobe synchronization during
silence feature On or Off, and select the control panel to report events by zone or by
point.
To edit miscellaneous options 2:
1. Enter the installer code.
2. Press
or
to display the main menu.
3. Select for Program Menu.
4. Select for System Options.
5. Select for Miscellaneous Options 2.
7.7.5.1 Synchronize Strobes Active During Silence
When “SYNC Strbs w/ Sil:” is Selected as Y (Yes) then strobes will continue to flash
when the system is silenced and will stop flashing when the system is reset.
Note: The “SYNC Strbs w/ Sil:” only functions with outputs that use a synchronized output pattern.
6. Press the or arrow to toggle this selection between Y (Yes) or N (No).
7. Press or to make your selection and move to the next programming option.
Note: See Section 7.4.1.4 for more information about Synchronization protocol choices.
7.7.5.2 Auto Display Oldest Event
When this feature is programmed Y (Yes) then the oldest un-acknowledge event will
automatically display on the control panel and remote annunciators after there has
been no activity on any system touch-pad for two minutes.
8. Press the or arrow to toggle this selection between Y (Yes) or N (No).
9. Press
or
to make your selection and move to the next programming option.
7.7.5.3 Report by Zone or by Point
When the “Report by” option is set to Zone, then the control panel will report events
by zone. If Point is selected then the control panel will report events by point.
ENTER
ACK
ENTER
ACK
ENTER
ACK
ENTER
ACK