Honeywell INTELLIKNIGHT 5820XL - Manual (Page 65)

Control Panel Installation
151209 4-25
4.9 5865-3 / 5865-4 LED Annunciator Installation
The 5865-3 and 5865-4 are LED annunciators. The 5865-4 has 30 mappable LEDs,
remote silence and reset key switches, and a general system trouble LED. The 5865-
3 has 30 mappable LEDs only. These are arranged as 15 pairs of red (typically used
for alarm) and yellow (typically used for trouble) LEDs.
Installation of the 5865-5 and 5865-4 is identical. The key switches and the trouble
LED follow the behavior of other system annunciators and do not require any
installation steps. The following sub-sections describe how to install the 5865-3 and
5865-4 hardware. Refer to Section 6 for programming information.
Note: This manual uses “5865” when referring to aspects of the 5865-3 and 5865-4 that are common
to both models.
Figure 4-24 5865-3 and 5865-4 Assembly (front view)
SILENCE
TROUBLE
RESET
5865-4 Board Assembly 5865-3 Board Assembly
Plexiglass plate mounted to LED board at factory.
Do not remove.
5865-4 switches
follow main FACP;
no installation
or programming
required.
Numbers indicate
point numbers for
5865. (They do
not appear on board
assembly.)
1 2
9 10
11 12 21 22
19 20 29 30
3 4
5 6
7 8
13 14
15 16
17 18
23 24
25 26
27 28