Honeywell INTELLIKNIGHT 5820XL - Manual (Page 73)

Control Panel Installation
151209 4-33
4.12.1.2 Class A Notification Wiring
You must use an appliance from the list of compatible appliances in the Appendix at
the back of this manual.
To install a Class A notification appliance circuit:
1. Wire the Class A notification appliances as shown in Figure 4-31.
2. Configure the circuit for Class A in programming (see Section 7.6).
Figure 4-31 Class A Notification Appliance Circuit Configuration
Note: In programming any point that uses multiple Flexput circuits, the lowest Flexput circuit number is
used to refer to the circuit pair. For example, Figure 4-31 uses both Flexput circuit 5 and 6, so in
programming it would be referred to as point 5.
Caution
For proper system supervision do not use looped wire under terminals marked O and X of the Flexput
connectors. Break wire runs to provide supervision of connections.
Supervised
Power Limited
Regulated 24 VDC Full Wave Rectified
27.4 VDC, 3A per Circuit, 6A max Combined