JumpStart automatically selects some options for SLC devices (see “JumpStart” section of this chart).
You can change options selected by JumpStart, if necessary and further customize input point
options.

Select device family (SK or SD). Only one device family can be used per
control panel.

7.2

Program type of switch (manual pull, fire drill, and so on), if necessary.
(JumpStart assigns all switches as Manual Pull type.)

7.6

If the installation includes duct detectors, program detector type. (JumpStart
does not distinguish duct detectors from ordinary smoke detectors.)

7.6

Assign a name (or description) to a point.

7.6.3.1

Assign input points to zones, if necessary. (JumpStart assigns all input points
to Zone 1.)

7.6

Zone Configuration

Add a zone to the system if it does not already exist. (Zone 1 created by
JumpStart.)

7.4.2

Assign a name (or description) to a zone.

7.4.1.1

Select alarm delay options (detection characteristics) for zone.

7.4.1.2

Select heat detector trip temperature. (JumpStart selects 150°F for heat
detectors.)

7.4.1.2

Output Point Configuration

Conventional notification circuits (circuits 1-6):

Enable circuits used for notification appliances through programming (if
necessary). (JumpStart enables circuits 1-6 as Notification.)

7.5.1

Conventional relay circuits (circuits 7-8):

Select options for relay circuits, if desired. Note: Relay circuits will always
output continuously (constant pattern), even if assigned to an Output Group
that uses a different output pattern.

7.5.1

Auxiliary power circuits (circuits 1-6):

Enable any circuit used for auxiliary power devices through programming.

7.6

Select type of power (door holder, constant, or resettable)

7.6

Addressable relay modules

Assign addressable relay modules to output groups through programming.
(JumpStart assigns all relay modules to Group 1.)

7.6

LED output points (from the 5880 LED I/O module or 5865/66 LED Annunciator)

Assign LED modules to output groups through programming.

7.6.3