Document Outline

• Automatic Generator Start
• About This Guide
  • Purpose
  • Scope
  • Firmware Revision
  • Audience
  • Organization
  • Conventions Used
  • Abbreviations and Acronyms
  • Related Information
  • Important Safety Instructions
  • General Precautions
  • Explosive Gas Precautions
  • FCC Information to the User
• Introduction
  • Front panel
  • Bottom panel
• Installation
  • Tools and materials required
  • Choosing a location
  • Routing the connections
  • Mounting the unit
  • Wiring to the 20-contact connector
  • Connecting the generator
    • Type 1
    • Type 2
    • Type 3
    • Type 4
    • Type 5
    • Type 6
    • Type 7
    • Type 8
    • Type 9
    • Type 10
    • Type 11
    • Type 12
    • Type 13
  • Connecting the thermostats (optional)
  • Connecting an external shutdown (optional)
  • Connecting an external manual on/off switch (optional)
    • Connecting an external on/off LED
  • Connecting the wiring harness to the Auto Gen Start
  • Connecting the control panel and other network-enabled devices
  • Verifying power is available
• Configuration
  • Using the System Control Panel
  • Changing Auto Gen Start settings using the System Control Panel
    • Viewing the Select Device menu
    • Viewing the Auto Gen Start menu
    • Selecting and adjusting the changeable setting
  • The Auto Gen Start basic menu
    • Gen Status
    • Gen Trigger
    • AGS Mode
    • QT Enable
    • QT Begin
    • QT End
    • Start SOC
    • Start DCV
    • Enable Temp1
    • Enable Temp2
    • Gen Type
    • Clear Faults
  • Auto Gen Start advanced menu
    • Configure Triggers
    • Configure Gen
    • View Device Info
    • Basic Menu
  • AGS Triggers menu
    • Start SOC
    • Stop SOC
    • StartV:30sec
    • StartV:15min
    • StartV:2hr
    • StartV:24hr
    • StopBattV
    • Enable Temp1
    • Enable Temp2
    • Enable Load
    • Start Load
    • Stop Load
    • Stop Absorb
    • Stop Float
  • Generator Configuration menu
    • Starter Cool Down
    • Max Run Time
    • Exercise Per
    • Exercise Dur
    • Exercise Time
    • Relay3
    • Run Hold Time
    • Crank Time
    • Crank Retry Time
    • Preheat Time
    • Start Tries
  • AGS: Device Info menu
    • View Fault Log
    • View Warning Log
    • View Event Log
    • Restore Defaults
• Operation
  • Enabling Quiet Time
  • Setting the beginning of Quiet Time
  • Setting the end of Quiet Time
  • Operating mode
  • Power Save mode
  • Safe mode
  • Hibernate mode
• Troubleshooting
• Specifications
• Generator Auto Start Requirements and Types
  • Two wire
    • Identification
    • Connection
  • Three-Wire Onan
    • Identification
    • Connection
  • Three-Wire Automotive
    • Identification
    • Connection
• Relay Timing
  • What does this warranty cover?
  • What will Xantrex do?
  • How do you get service?
  • What proof of purchase is required?
  • What does this warranty not cover?
  • If you are returning a product from outside of the USA or Canada
  • If you are returning a product to a Xantrex Authorized Service Center (ASC)
  • Xantrex Technology Inc.