Xantrex Technology Automatic Generator - Manual (Page 64)

Configuration
3–16 975-0082-01-01
Enable Temp2
Full name Enable Thermostat 2.
Purpose “Enable Temp2” is intended to be used when the Auto Gen Start is
connected to a second thermostat. All information and procedures for
“Enable Temp1” also apply for “Enable Temp2”.
Gen Type
Full name Generator type
Purpose “Gen Type” is a changeable setting for selecting the starting requirements
of your generator. The starting requirements determine how the Auto Gen
Start must be wired to the generator’s starting system. For more
information, see “Connecting the generator” on page 2–9 or Appendix B.
Values Default
On, Off Off (disabled)
Important:
You can only change “Gen Type” after you have put the system
into Safe mode. See “Changing System Modes” on page 4–6.
Option
Description
Configuration Mode
Type 1 General GlowStop
Type 2 Onan Diesel (Default) GlowStop with no preheat
Type 3 General GlowStop with shutdown bypass
Type 4 Guardian/Generac Gas StartStop with Relay 3 prime
Type 5 Guardian/Generac Diesel StartStop with Relay 3 preheat
Type 6 Yamaha GlowStop with normally closed
RunStop contact
Type 7 Generac Backup/
Renewable Run with preheat
Type 8 Northern Lights and Fisher
Panda Run with no preheat
Type 9 Westerbeke StartStop with Relay 3 preheat and
shutdown bypass