Matsushita CF-W5LWEZZ1 2 - Manual (Page 45)

45
9.3.2.13. Assembly of the WWAN Board
9.3.2.14. Putting Tapes for WM Cable
WWAN board
WM cable
Screw
Screw
Rear wall application
LCD hook WAN
LCD hook Wan installation standard
Connection
Rear wall application
There is no order specification
excluding a specified part.
The oreder of tightening screw (LCD hook WAN) :
The oreder of tightening screw (WWAN board) :
PET tape
Refer to Figure 1
Root fixation
The cable must not stretch. The cable must not stretch.
A two sided tape of the cable after the cable position A two sided tape of the cable after the cable position
of Figure 1 is put out is affixed (cable fixation).
of Figure 1 is put out is affixed (cable fixation).
A two sided tape of the cable after the cable position
of Figure 1 is put out is affixed (cable fixation)
This is affixed along shape so that Conduction Cloth
should not float. This is affixed along shape so that conduction cloth
should not float.
Safety work
Conduction cloth
The convex part is
matched to a red line.
Conductive cloth
must not hang to
PET tape
Edge side standard
of conduction cloth