ICP DAS USA I-7540D - Manual (Page 106)

6. Application with PISO-CAN 200/400 T
In this chapter, we describe the i-7540D application in CAN network. On the
CAN bus side, the device is the PISO-CAN200/400-T of ICP DAS. And here the
i-7540D is a CAN-Ethernet gateway device. It allows users to send specific
commands from It’s Ethernet port10003 to CAN bus. Receive response message
form CAN bus and then convert these CAN messages to specific commands.
After converting, it sent these specific commands to those who establish
connection with it from port 10003. The architecture is depicted as figure 5-1.
Figure 6-1 Architecture of the demo in PISO-CAN200/400 PCI card
The information of devices and software in this application is below:
z
Hardware:
CAN bus side: PISO-CAN 200/400-T
Ethernet side: PC with VxComm technology
CAN-Ethernet Gateway: i-7540D
z
Software:
CAN bus side: the utility in PISO-CAN200/400 PCI card
Ethernet side: send232 tool in MiniOs7 Utility.
i-7540D CAN-Ethernet Gateway User’s Manual (Version 1.4, April/2008) 106