Smart Technologies ID422w - Manual (Page 21)

11 | CHAPTER 2 – INSTALLING THE SMART PODIUM ID422w
Installing the Interactive Pen Display
IMPORTANT
Do not connect the USB data cable until instructed to do so.
To install the interactive
pen display
1. If you are using a second device, such as a projector or a monitor, follow the
instructions on page 13 to connect the interactive pen display to the second
device.
CAUTIONS
–
Do not connect or disconnect the video or power cable if the interactive
pen display or your computer is on. If you do, you can damage the screen
and/or the computer video card.
– Use only the power adapter that came with the SMART Podium ID422w.
Other adapters will not work properly, can damage the interactive pen
display and can create a fire hazard. Using a different power adapter also
voids the warranty.
– Make sure that the display refresh rate does not exceed 76 Hz.
IMPORTANT
–
Fully install the SMART Podium ID422w hardware (page 9) and software
(page 15) before connecting a projector or monitor to the unit.
2. Turn on the computer and the interactive pen display.
The SMART Podium ID422w automatically installs as a default monitor.
3. If necessary, configure the display control panel settings for the proper size and
colour resolution. The maximum (native) resolution of the SMART Podium
ID422w is 1920 × 1080 pixels. The display size and colour resolution may be
constrained by the capabilities of your video card. For more information, see the
video card manufacturer’s documentation.
NOTE
If your computer supports a second display and you are using the interactive
pen display as a second display, you may need to enable the SMART Podium
ID422w as your second display in your Display Properties (Windows
computers) or Display preferences (Mac computers).
4. If necessary, adjust the screen display settings (see page 19).
IMPORTANT
To extend the life of the backlight, set your computer’s power management
settings to turn off the display when it is not in use for extended periods.