Smart Technologies ID422w - Manual (Page 5)

iii | – IMPORTANT INFORMATION
CAUTIONS – INTERACTIVE PEN DISPLAY
•
Do not place sharp or heavy objects on the interactive pen display.
• Do not connect or disconnect the video or power cable if the interactive pen
display or your computer is on. If you do, you can damage the screen and/or
the computer video card.
• Do not block the interactive pen display’s ventilation holes, as this can cause
it to overheat.
• If you move the interactive pen display, adjust the display stand to its full
upright position, and then use both hands to hold the display unit and the
stand separately. Use the rotation lock screws to ensure that the stand will not
separate from the display unit.
• Do not expose your interactive pen display to high voltage electrostatic
discharges or to a build-up of electrostatic charge on the screen. This can
cause discoloration and blotches on the screen.
• If the interactive pen display is damaged, turn off the display, disconnect the
power adapter in order to prevent further damage or personal injury.
CAUTIONS – TETHERED PEN
•
The tethered pen is a sealed unit that contains electronics but no batteries.
If you attempt to open the tethered pen, you will damage these electronics.
This will make the tethered pen unusable and void the warranty.
• Do not touch the screen with any instrument other than the supplied pen
because other instruments may damage the screen’s protective coating.
• Do not use a pen that has worn down to a sharp or angular tip, as it may
damage the screen.
• Do not apply excessive pressure that can shorten the life of the pen.
• Do not immerse the pen in water.
CAUTIONS – ENVIRONMENT
•
Avoid setting up and using the interactive pen display in an area with
excessive levels of dust, humidity and smoke or where it is exposed to direct
sunlight, severe temperature changes, heat from other appliances, water or
any other liquid. Operate the interactive pen display within a temperature
range of 5°C and 35°C (41°F 5°C to 95°F) and a humidity range of 20% to
80% (non-condensing). However, you can store the interactive pen display
within a temperature range of -10°C to 60°C (14°F to 140°F) and a humidity
range of 20% to 90% (non-condensing).