Smart Technologies ID422w - Manual (Page 32)

22 | CHAPTER 2 – INSTALLING THE SMART PODIUM ID422w
To use the
Auto Adjust (VGA only)
option
1. Press the Menu button on the interactive pen display to open the OSD menu.
2. Press the – and + buttons to select the Other option , and then press the
Enter button.
The Other menu appears.
3. Press the – and + buttons to select Auto Adjust.
4. Press the Enter button to save your changes and select another option.
OR
Press the Menu button to exit the OSD menu.
NOTES
•
The OSD menu closes automatically after a few moments of inactivity.
• You can also press the Menu button to close the OSD menu.
• Your settings are saved automatically when the OSD menu closes and
appear the next time the unit receives a similar video signal. This is applicable
to all display modes. If you change your settings, you can select Reset to
return the SMART Podium ID422w to its original factory defaults.
Adjusting Phase and Pitch (VGA Only)
Some computers and graphics cards may not allow Auto Adjust to function correctly
when you first connect the screen. If the display does not fit within the LCD panel
border, or if some portion of the text appears blurred, adjust the phase and pitch.
To adjust the phase and
pitch (VGA only)
1. Press the Menu button on the interactive pen display to open the OSD menu.
2. Press the – and + buttons to select the Other option and then press the
Enter button.
The Other menu appears.
3. Select the Phase option and then use the – and + buttons to make the adjustment
pattern show clearly.
4. Select the Pitch option and then use the – and + buttons to evenly display the
pattern of vertical stripes on the screen.
5. Press the Enter button to save your changes and select another option.
OR
Press the Menu button to exit the OSD menu.