Smart Technologies ID422w - Manual (Page 23)

13 | CHAPTER 2 – INSTALLING THE SMART PODIUM ID422w
Integrating a Monitor or a Projector
You can connect a projector or another monitor directly to the interactive pen display.
With this setup, whatever you view on the interactive pen display also appears on the
other display. When you connect a projector or a monitor, the video signal from the
computer is automatically sent to the projector or monitor. Other integration options
are available if you amplify the video signal.
Use a SMART approved projector, such as the UF55w or UX60 projectors.
Alternatively, use a projector that can support VGA resolution and change the display
resolution of the connected computer.
NOTE
The display resolution of the connected computer must be set to a resolution
supported by the projector.
To connect a projector
or monitor
1. Turn off the computer and the interactive pen display.
2. For DVI operation, connect a second DVI to DVI video cable (not included) to the
DVI-I OUT port located on the interactive pen display and the DVI-D or DVI-I
Video Input connector on your projector or monitor.
For VGA operation, connect a second VGA to DVI-A cable (not included) to the
DVI-I OUT port located on the interactive pen display and the VGA Video Input
connector on your projector or monitor.
NOTE
For details about the projector’s connectors, read the instructions that came
with your projector.