Lennox Hearth G8 - Manual (Page 104)

5.10 Replacing the Elevation Gyro
1. Disconnect the gyro cable from the in-line
connector.
2. Remove the two M2.5 screws securing the gyro to
the LNB/feed tube assembly. Remove the old
gyro.
3. Apply a drop of Loctite threadlocker to the threads
of the screws that you removed in Step 2. Install
the new elevation gyro and secure in place with
the two screws.
4. Connect the new gyro cable to the in-line
connector that you disconnected in Step 1.
5. Calibrate the gyro as described in “Calibrating the
Gyros” on page 105 .
54-0198 106
TracVision G8 Owner’s Manual - Guide to Technical Information
Figure 5-21
Elevation Gyro
Gyro Cable
Connector
M2.5 Screws
(x 2)
Gyro
LNB
Reflector