Lennox Hearth G8 - Manual (Page 46)

Installation
54-0198 43
Installing Your Selected Satellites
To install your selected satellites as Satellite A and Satellite B,
follow the steps below.
1. Apply power to the MCU.
2. Following the startup sequence, press the center
button to bring up the “Install Satellite?” screen.
3. Follow the process shown in Figure 2-23 on the
following page to install your selected satellites. At
the end of the process, be sure to press the YES
button to restart the antenna.
Install Satellite?
Enter Next Return
Section 3, “Using the MCU
Interface,” provides complete details
on the use of the MCU menus,
including complete antenna control
details in
“Control Antenna Mode”
on page 68 .
Figure 2-22
Install Satellite Screen