Lennox Hearth G8 - Manual (Page 33)

16. At each of the four baseplate mounting holes,
place an M10 lock washer and flat washer on an
M10 bolt and insert the bolt into the hole from
below, as shown in Figure 2-12. Tighten all four
bolts securely until the four feet are bottomed
against the mounting surface.
17. Reinstall the radome. Secure in place with the
eight screws removed in Step 6. Install a protective
plastic screw cap from the kitpack over each
screw.
54-0198 30
TracVision G8 Owner’s Manual - Guide to Technical Information
Figure 2-12
Bolting the Antenna Unit to
the Deck (Side View)
M10 x 1.5 Hex-head Bolt
Antenna Unit Base
Deck
M10 Flat Washer
M10 Lock Washer